Technical Support Q&A

Question 1

What is the maximum configuration for connecting multiple Victron NG batteries? View answer

Asked 10 ´months ago | Technical Support

Question 2

How does the Victron NG batteries communication and monitoring work? View answer

Asked 10 ´months ago | Technical Support

Question 3

What are the key features of the Victron 12.8 Volt Lithium NG batteries? View answer

Asked 10 ´months ago | Technical Support

Question 4

Can 2 Victron Phoenix Smart IP43 12/50 Chargers be set up in parallel for 100A output? View answer

Asked 11 ´months ago | Victron IP43 Chargers > Phoenix Smart IP43 Charger 12/50(1+1)

Question 5

How may pulses per revolution Will the Balmer XT-170 output for an rpm signal? View answer

Asked 1 ´year ago | Technical Support

Question 6

Is the Cerbo GX capable of replacing the Skylla-i Control panel? View answer

Asked 1 ´year ago | Skylla IP65 Chargers > Victron Energy REC000300010R Skylla-i Control GX Remote Panel

Question 7

Does an Orion TR dc to dc charger need a battey on both sides? View answer

Asked 1 ´year ago | Technical Support

Question 8

Where in the ABYC does it list the fuse requirement for an LFP battery? AIC? View answer

Asked 1 ´year ago | Older generation Lithium Smart Batteries > Victron BAT512120610 Smart Lithium Iron Phosphate Battery 12.8V 200 Ahr

Question 9

Relative advantages of having an LFP battery BMS integrated into the battery, or separate? View answer

Asked 1 ´year ago | Older generation Lithium Smart Batteries > Victron BAT512120610 Smart Lithium Iron Phosphate Battery 12.8V 200 Ahr

Question 10

Is there some reason that Source Selector Switches and MPTPs take bare wire terminations instead of ring terminals View answer

Asked 1 ´year ago | AC Source Selector Switches > Blue Sea 9011 AC Selector AC Selector Switch,120V 63A OFF +2

Question 11

Does the Ekrano GX's generator feature support a Westerbeke 7.6 BTD? View answer

Asked 1 ´year ago | Communication Centers > Victron Energy BPP900480100 Ekrano GX

Question 12

Re the victron multiplus 12/1200/50. Do the gst18 power cables or plugs come with unit? Do you sell them? Thanks View answer

Asked 1 ´year ago | Technical Support

Question 13

wiring isolators from three sources to three battery banks View answer

Asked 1 ´year ago | FET Battery Isolators > Victron ARG100301020 Argofet 100 Amp Diode Battery Isolator for three batteries

Question 14

Can this dongle will connect directly to Victron 75/15 MPPT solar controller? View answer

Asked 2 ´years ago | Solar Charge Controller Accessories > Victron VE.Direct Bluetooth Smart dongle

Question 15

If I have three of these hooked up to a 702 and two MPPT75/15 controllers, can one tablet (iOS or Android) monitor all three at the same time? And display all three too? View answer

Asked 2 ´years ago | Solar Charge Controller Accessories > Victron VE.Direct Bluetooth Smart dongle

Question 16

Can thie mini add a battery system be used with both a cranking battery and a deep cycle battery? View answer

Asked 2 ´years ago | Relays, Solenoids and Combiners > Blue Sea 7649 Mini Add-A-Battery System

Question 17

Will this work with my 2010 merc 4 stroke 90 HP, is it compatible? View answer

Asked 2 ´years ago | Relays, Solenoids and Combiners > Blue Sea 7649 Mini Add-A-Battery System

Question 18

Is this a 6 groove belt? Looking for a 6 groove 49" belt View answer

Asked 2 ´years ago | Pulley Kits > Spare J10 Style Serpentine Belt

Question 19

Do you have these belts in stock? View answer

Asked 2 ´years ago | Pulley Kits > Spare J10 Style Serpentine Belt

Question 20

Can you tell me the part number or length for a spare serpentine belt for the 48-YSP-3JH-E? View answer

Asked 2 ´years ago | Pulley Kits > Spare J10 Style Serpentine Belt

Question 21

How many belts in this package, Picture shows 2? View answer

Asked 2 ´years ago | Pulley Kits > Spare J10 Style Serpentine Belt

Question 22

How do I take the 2.7" pulley off the Balmar 6 series? Do I need a gear puller or is there a key on the shaft? View answer

Asked 2 ´years ago | Balmar Pulleys > Balmar Pulleys not listed elsewhere

Question 23

Can this unit be commanded to turn off directly from the Victron Connect App using a phone? View answer

Asked 2 ´years ago | Battery Protects > Victron Energy BPR122022000 Smart BatteryProtect with Bluetooth 12/24V -220A

Question 24

Can this be used with a Mac and Victron Connect to program a MultiPlus? View answer

Asked 2 ´years ago | Inverter & Charger Accessories > Victron Energy ASS030140000 MK3 USB Interface (VE.Bus to USB-A)

Question 25

What is the diffirance between Mk2 and Mk3 ? View answer

Asked 2 ´years ago | Inverter & Charger Accessories > Victron Energy ASS030140000 MK3 USB Interface (VE.Bus to USB-A)

Question 26

Hi Peter, the GX manuals say connect this to the VE.bus network. Does this mean I can connect it to the Cerbo GX (more convenient for me) or does it have to be connected directly to my Multiplus? thx View answer

Asked 2 ´years ago | Technical Support

Question 27

Do you have a serpentine kit for a Universal M35B. It's on a Catalina 34 MKII. View answer

Asked 2 ´years ago | Balmar 48-USP-M25 Pulley Kit for Universal M25, M-A

Question 28

I have a universal M25 engine. I want to fit a Balmar series 6 100 Amp alternator. My current V-belt is 3/8 wide. I want a pulley conversion kit for a single V-belt I presume it is 1/2 inch wide.... unless there is a good reason not to. Does Balmar make a kit like that? View answer

Asked 2 ´years ago | Balmar 48-USP-M25 Pulley Kit for Universal M25, M-A

Question 29

Is the Balmar MC-618 sufficient protection for the alternator in the event of a lithium battery BMS shutoff of charging current? View answer

Asked 2 ´years ago | Balmar regulators and accessories > Balmar MC-618-H Voltage Regulator with harness 12 Volts

Question 30

Hi, Is the the cable to SG200 included with this? Thanks View answer

Asked 2 ´years ago | Balmar regulators and accessories > Balmar MC-618-H Voltage Regulator with harness 12 Volts

Question 31

MC-18-H I am installing two Victron 200ah lithium batteries and a lynx smart BMS. A have an Ample power 12v 124/106 saddle mount small case alternator. Will your MC-18_H and its wiring harness work with this? Thank you View answer

Asked 2 ´years ago | Balmar regulators and accessories > Balmar MC-618-H Voltage Regulator with harness 12 Volts

Question 32

Can the Bluetooth dongle be used to program the regulator without the SG200 display component. View answer

Asked 2 ´years ago | Balmar regulators and accessories > Balmar MC-618-H Voltage Regulator with harness 12 Volts

Question 33

Is there derating information for using smaller cables? My continuous load is only about 125A @ 24VDC, and I'd like to stay with smaller cables. Thanks! View answer

Asked 2 ´years ago | Relays, Solenoids and Combiners > Blue Sea 7622 ML-Series 500 Amp 12 Volt ACR

Question 34

Hi, do you have a box to inclose this? Thank You. View answer

Asked 2 ´years ago | AC Main Panels > Blue Sea 8077 AC Panel Main 120VAC 30A

Question 35

Can this switch be reversed, so that the load side is used for incoming current and the Shore/Gen positions be used for output to two separate circuits? Thanks View answer

Asked 2 ´years ago | AC Source Selector Switches > Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2

Question 36

Is there a CAD file available for the Blue Sea 9009 AC selector switch? Thanks View answer

Asked 2 ´years ago | AC Source Selector Switches > Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2

Question 37

Can I use switch #9009 for two separate loads? View answer

Asked 2 ´years ago | AC Source Selector Switches > Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2

Question 38

Does this switch also shut off the neutral wire for the generator? View answer

Asked 2 ´years ago | AC Source Selector Switches > Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2

Question 39

Can it be wired to turn off both the cranking battery and trolling motors batteries. It currently does not shut of cranking battery View answer

Asked 2 ´years ago | Battery Switches > Blue Sea 6011 Mini Dual Circuit Plus Battery Switch

Question 40

Why are some of these switches red and some black? They seem to be the same otherwise?. View answer

Asked 2 ´years ago | Battery Switches > Blue Sea 6011 Mini Dual Circuit Plus Battery Switch

Question 41

The panel has 8 AC breaker positions and 18 DC breaker positions however not all positions have breakers/switches. What is the additional costs to fill all of these positions? View answer

Asked 2 ´years ago | Blue Sea 8408 AC Panel 8/DC18 pos w/ AC & DC Multimeter

Question 42

Will this kit work for the Yanmar 2GM20-F with the stock Hitachi alternator ? View answer

Asked 2 ´years ago | Serpentine belt kits for Yanmar engines > Balmar 48-YSP-3GM-C Pulley Kit for Yanmar 3GM, 2GM-20

Question 43

Hi I've got a yanmar 2gm 20 raw water cooled with a stock 55amp hitachi alternator, do you do a sepentine belt-pulley kit upgrade. I'm planning on staying with the hitachi alternator for the short term. Thanks chris View answer

Asked 2 ´years ago | Serpentine belt kits for Yanmar engines > Balmar 48-YSP-3GM-C Pulley Kit for Yanmar 3GM, 2GM-20

Question 44

I need the packaged weight and dimensions of this kit to forward onto Panama. Thanks View answer

Asked 2 ´years ago | 6 Series Dual Foot Mount with K6 Pulley > Balmar 60-YP-24-70-K6 Alternator and regulator kit -24 Volt 70 Amp K6 Pulley

Question 45

How much does this kit weigh? I'm trying to determine shipping costs to Panama. View answer

Asked 2 ´years ago | 6 Series Dual Foot Mount with K6 Pulley > Balmar 60-YP-24-70-K6 Alternator and regulator kit -24 Volt 70 Amp K6 Pulley

Question 46

What is the shipping weight of this item? Balmar 48-YSP-4JH-B View answer

Asked 2 ´years ago | Serpentine belt kits for Yanmar engines > Balmar 48-YSP-4JH-B Pulley Kit for Yanmar 4JH4, -TE, HTE, -DTE

Question 47

Does this kit fit the Yanmar 4JH4AE engine? View answer

Asked 2 ´years ago | Serpentine belt kits for Yanmar engines > Balmar 48-YSP-4JH-B Pulley Kit for Yanmar 4JH4, -TE, HTE, -DTE

Question 48

What is the diameter of the pulleys? I am looking for a serpentine pulley approximately 250mm in dia. View answer

Asked 2 ´years ago | Balmar 48-WSP-12C Pulley Kit for Westerbeke 12C, 12D, 20B, 30B

Question 49

What is the thickness of the new crankshaft pulley. I do not have much room and want to make sure it will fit before ordering. View answer

Asked 2 ´years ago | Balmar 48-WSP-12C Pulley Kit for Westerbeke 12C, 12D, 20B, 30B

Question 50

What is the parasitical draw? View answer

Asked 2 ´years ago | 12 Volt Accessories > Marinco SeaLink Deluxe Dual USB Charger and 12V Receptacle

Technical Support Q&A

Activity timeframe

Browse by Topic

Tools