Answer posted 8 months ago | Balmar 48-YSP-4JH-E Pulley Kit for Yanmar 4JH2-E -TE -HTE -DTE -UTE
Answer:
Yes the Balmar 48-YSP-4JH-E Pulley Kit is the right kit for the Yanmar 4JH2-E
Is the connection on this a 3/8 th
Answer posted 8 months ago | Balmar MC-TS-A Alternator Temperature Sensor
Answer:
The battery temp sensor has a 3/8" connector but the alternator sensor is smaller, Its terminal is 1/4"
Answer posted 8 months ago | Balmar MC-TS-A Alternator Temperature Sensor
Answer:
We tried this and it worked. You might need to do a bit of calibration for maximum accuracy.
Answer posted 8 months ago | Victron Energy PMP122200102 MultiPlus 12/2000/80-50 120V VE.Bus (UL Listed)
Answer:
Yes it does. Its a pretty small output though, clocking it at just 1 amp.
What gauge wire does the device have?
Answer posted 8 months ago | Victron Energy SBS050150200 Long Range Bluetooth Smart Battery Sense
Answer:
It appears to use 18 awg or similar
Can the Victron Smart Battery Sense function with any type of batteries?
Answer posted 8 months ago | Victron Energy SBS050150200 Long Range Bluetooth Smart Battery Sense
Answer:
Yes it should work with any 12, 24 or 48 volt battery bank.
Whats the difference between isolated and non isolated, and why would I choose one over the other?
Answer posted 8 months ago | Victron Energy ORI121222120 Orion-Tr Smart 12/12-18A Isolated DC-DC charger
Answer:
This question is addressed in my article Isolated vs Non-Isolated DC DC Charger?
Is the Asus USB-N14 compatible with the Cerbo GX?
Answer posted 8 months ago | Victron Energy BPP900200300 CCGX Long Range WiFi Module (ASUS USB-N14)
Answer:
Yes you can use the Asus USB-N14 to increase the WiFi range of the Cerbo GX
Answer posted 8 months ago | Victron Energy SHU050150050 SmartShunt 500A/50mV (Standard version)
Answer:
Yes it does.
Can we use 10 or 8 gauge wire for the Victron 75-15 MPPT solar charge controller?
Answer posted 8 months ago | Victron Energy SCC075015060 Smart Solar MPPT 75/15 Charge Controller with Bluetooth
Answer:
The MPPT 75/15 will accept a maximum of 10 awg wire
Is the Phoenix smart charger ignition protected?
Answer posted 8 months ago | Phoenix Smart IP43 Charger 12/30(3)
Answer:
No sorry, none of the Victron chargers are ignition protected.
Is this priced with the wiring harness?
Answer posted 9 months ago | Balmar MC-618-H Voltage Regulator with harness 12 Volts
Answer:
The "H" in the part number MC-618-H denotes that the wire harness is included,
Can thie mini add a battery system be used with both a cranking battery and a deep cycle battery?
Answer posted 9 months ago | Blue Sea 7649 Mini Add-A-Battery System
Answer:
Yes it can as long as they are otherwise the same in chemistry
Can you tell me the part number or length for a spare serpentine belt for the 48-YSP-3JH-E?
Answer posted 9 months ago | Spare Serpentine Belt
Answer:
The 48-YSP-3JH-E kit used a 46" belt which should be marked J460
Can this be used to turn off a 24v battery system for my trolling motor?
Answer posted 9 months ago | Blue Sea 6006 Mini ON-OFF Battery Switch
Answer:
Yes this switch can be used for up to 48 volts DC
Can this temperature sensor, work with Cerbo GX?
Asked 9 ´months ago | Victron Energy ASS000001000 temp sensor for Quattro, MultiPlus and Cerbo GX
Answer:
Yes the Victron Energy ASS000001000 temp sensor is compatible with the Cerbo GX.
Does the MultiPlus/Quattro Inverter Charger include a temperature sensor?
Asked 9 ´months ago | Victron Energy ASS000001000 temp sensor for Quattro, MultiPlus and Cerbo GX
Answer:
Yes, each MultiPlus or Quattro Inverter Charger comes with a temperature sensor.
What are the dimensions of the Argo Battery Combiner?
Asked 9 ´months ago | Victron Energy BCD000802000 Argo BCD802 Diode Battery Combiner
Answer:
The battery combiner, Victron Energy BCD000802000 Argo BCD802 Diode, measures 2.4" x 4.7" x 3" in dimensions.
How many battery banks can the Argo Battery Combiner support?
Asked 9 ´months ago | Victron Energy BCD000802000 Argo BCD802 Diode Battery Combiner
Answer:
The Victron Energy BCD000802000 Argo BCD802 Diode Battery Combiner has the capacity to support two battery banks.
Can this cable be used to interface with the victron Cerbo unit?
Answer posted 9 months ago | Victron ASS030530010 VE. Direct to Standard USB interface cable
Answer:
It is used to connect a VE Direct device (such as an MPPT) to the Cerbo.
How long is the temperature sensor ASS000001000 included with a multiplus
Answer posted 9 months ago | Victron Energy ASS000001000 temp sensor for Quattro, MultiPlus and Cerbo GX
Answer:
The cable is about 4 ft long
Cn the 3600 Isolation transformer take an input of 240V 50Hz and output 115V 60Hz ?
Answer posted 9 months ago | Victron Energy ITR050362041 Isolation Transformer 3600W with autodetect input voltage
Answer:
This transformer can change the voltage but not the frequency.
Does the Balmar MC-618 come with a Lithium profile?
Asked 9 ´months ago | Balmar MC-618-H Voltage Regulator with harness 12 Volts
Answer:
Yes, the Balmar MC-618 does feature a built-in Lithium profile.
Can the input/output current be configured on the Orion XS?
Asked 9 ´months ago | Victron ORI121217040 Orion XS 12/12-50 non-isolated DC-DC charger
Answer:
Indeed, the Orion XS 12/12-50A allows for the configuration of the input/output current up to 50A.
What cable do I need to to connect the Mk3 USB interface to a MultiPlus?
Answer posted 9 months ago | Victron Energy ASS030140000 MK3-USB Interface (VE.Bus to standard USB)
Answer:
This requires a VE Bus cable.
Answer posted 9 months ago | Victron Energy Orion 24/12-40 DC-DC Converter with 40 Amp Output p/n ORI241240021
Answer:
The converter uses push on connectors and they do not support 40 amps so they doubled them up.
Do you have a serpentine kit for a Universal M35B. It's on a Catalina 34 MKII.
Answer posted 9 months ago | Balmar 48-USP-M25 Pulley Kit for Universal M25, M-A
Answer:
The kit for the Universal 35B is the Balmar 48-USP-M35B Pulley Kit for Universal M35B, M25XPB, M40B
Does the AC Selector Switch provide circuit protection?
Asked 9 ´months ago | Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2
Answer:
No, the AC Selector Switch is a compact solution when circuit protection is provided elsewhere.
What is the function of the AC Selector Switch?
Asked 9 ´months ago | Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2
Answer:
The AC Selector Switch is used for connecting one of two 120V AC sources to a single load.
Does this 100 amp marine alternator have an isolated groun?
Asked 9 ´months ago | Balmar 621-100-SV Alternator -12 Volt 100 Amp Single Pulley
Answer:
The all the 6 series alternators come with an isolated ground as standard.
Does the blue sea 8077 device offer both switching and circuit protection?
Asked 9 ´months ago | Blue Sea 8077 AC Panel Main 120VAC 30A
Answer:
Yes, the blue sea 8077 integrates both switching and circuit protection within a single device.
Which fuses are compatible with the safety hub SafetyHub100?
Asked 9 ´months ago | Blue Sea 7725 Fuse Block Safety Hub 100
Answer:
The safety hub, SafetyHub100, is compatible with three 30A-200A MIDI fuses and four 1A-20A ATO/ATC fuses.
Does the Blue Sea 5032 fuse block offer storage for spare fuses?
Asked 9 ´months ago | Blue Sea 5032 Split Bus Fuse Block for 2 sets of 6 Fuses
Answer:
Yes, the blue sea 5032 cover does provide storage for two spare fuses.
Which adjustment arm is right for a Yanmar 4JH4 engine?
Asked 9 ´months ago | Balmar 48-YSP-4JH-B Pulley Kit for Yanmar 4JH4, -TE, HTE, -DTE
Answer:
For the Yanmar 4JH4 engine, the UBB2 is the appropriate adjustment arm.
What's the rating of the 12v usb outlet in the SeaLink charger?
Asked 9 ´months ago | Marinco SeaLink Deluxe Dual USB Charger and 12V Receptacle
Answer:
The 12 volt receptacle that comes with the SeaLink USB charger has a rating of 20 amps.
Does the AC Selector Switch come with circuit protection?
Asked 9 ´months ago | Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2
Answer:
No, the AC Selector Switch is a compact solution when circuit protection is provided elsewhere.
What is the purpose of the AC Selector Switch?
Asked 9 ´months ago | Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2
Answer:
The AC Selector Switch is used for connecting one of two 120V AC sources to a single load.
Can this Skylla be controlled by a Lithium battery BMS
Answer posted 9 months ago | Victron Energy SDTG2401003 Skylla-TG 24/100(1+1) GL 120-240V Battery Charger
Answer:
This charger is not suitable for charging lithium batteries and has no lithium program.
Answer posted 9 months ago | Marinco SeaLink Deluxe Dual USB Charger and 12V Receptacle
Answer:
If you do this as two separate holes they would each want to be 1 1/8" diameter.
Does this include the wires to connect?
Answer posted 9 months ago | Marinco SeaLink Deluxe Dual USB Charger and 12V Receptacle
Answer:
No you will have to provide your own wires for this.
Which batteries can the Lynx Smart BMS work with?
Asked 9 ´months ago | Victron Energy LYN034170210 Lynx Smart BMS 1000 (M10)
Answer:
The Lynx Smart BMS is specifically designed to work exclusively with Victron Smart Lithium Batteries.
Is the Lynx Smart BMS compatible with my type of batteries?
Asked 9 ´months ago | Victron Energy LYN034170210 Lynx Smart BMS 1000 (M10)
Answer:
The Lynx Smart BMS is only intended to be used with Victron Smart Lithium Batteries.
Can I design these custom circuit breaker panels online?
Asked 9 ´months ago | Blue Sea Systems Custom Made Circuit Breaker Panel
Answer:
Sure, you can design these panels using the Panelwizard program offered by Blue Sea Systems online.
How much does this 48/10000 Victron Quattro inverter charger weigh?
Asked 9 ´months ago | Victron QUA483100100 Quattro 48/10000/140-100/100 120V VE.Bus
Answer:
The Victron Quattro 48/10000/140-100/100 120V VE.Bus weighs 128 Lbs.
Can I use switch #9009 for two separate loads?
Answer posted 9 months ago | Blue Sea 9009 AC Selector Switch, 120V 32A OFF +2
Answer:
This switch just has a single output, there are not two independent outputs
Hello, How long is the wire for this product? Thanks
Answer posted 9 months ago | Victron Energy ASS000100000 Temperature Sensor for BMV 702/712 and Smart Shunt
Answer:
This wire is approx 4 ft long.
What is the transfer capacity of the Quattro 48/10000/140-100/100 120V VE.Bus
Asked 9 ´months ago | Victron QUA483100100 Quattro 48/10000/140-100/100 120V VE.Bus
Answer:
The Quattro 48/10000/140-100/100 120V VE.Bus has a transfer capacity of 100 amps on both its inputs.
Answer posted 9 months ago | Blue Sea 6011 Mini Dual Circuit Plus Battery Switch
I need the packaged weight and dimensions of this kit to forward onto Panama. Thanks
Answer posted 9 months ago | Balmar 60-YP-24-70-K6 Alternator and regulator kit -24 Volt 70 Amp K6 Pulley
Answer:
The box is 14 x 12 x 12 inches and lists as 20 Lbs
What's the voltage of this Victron Quattro model?
Asked 9 ´months ago | Victron QUA483100100 Quattro 48/10000/140-100/100 120V VE.Bus
Answer:
The Victron Quattro 48/10000/140-100/100 120V VE.Bus is for 48 volts DC, 120 volts AC
