Will the Victron Energy MPPT Control, when paired with a Victron BlueSolar Charge Controller MPPT 150/35, give you the status of the battery charge in a percentage as well as by voltage? View answer
Asked 2 ´years ago | Solar Charge Controller Accessories > Victron Energy SCC900500000 MPPT Control
If the max alternator output is around 65-70- amps which isolator rating would be recommended, the 100 or the 200? A tech advised me to double the output for the isolator. Is this correct? View answer
Asked 2 ´years ago | FET Battery Isolators > Victron ARG200301020 Argofet 200 Amp Diode Battery Isolator for three batteries
Re your FET battery isolator: I can see the ground terminal but can not tell what type of connection it is, can you advise? Also, do you carry a two battery version at 200 A. View answer
Asked 2 ´years ago | FET Battery Isolators > Victron ARG200301020 Argofet 200 Amp Diode Battery Isolator for three batteries
I would like to enable the device with ignition switch and remote switch. What gauge wire is needed to run to the starter power supply? Does this also require an inline fuse? View answer
Asked 2 ´years ago | Smart DC Chargers > Victron Energy ORI122436140 Orion-Tr Smart 12/24-15A Non-Isolated DC-DC charger
Does the Victron Energy ORI241225020 Orion 24/12-25A DC-DC Converter have staged charge levels for maintaining a lead acid battery? I'd like to run it off my LiFePO4 bank to keep my starter battery topped off. View answer
Asked 2 ´years ago | 24 volt input Step Down DC DC Converters > Victron Energy ORI241225020 Orion 24/12-25A DC-DC Converter
Connecting SmartSolar MPPT and MultiPlus to Cerbo GX View answer
Asked 2 ´years ago | Communication Centers > Cerbo GX Mk2
I have a universal M25 engine. I want to fit a Balmar series 6 100 Amp alternator. My current V-belt is 3/8 wide. I want a pulley conversion kit for a single V-belt I presume it is 1/2 inch wide.... unless there is a good reason not to. Does Balmar make a kit like that? View answer
Asked 2 ´years ago | Balmar 48-USP-M25 Pulley Kit for Universal M25, M-A
I have bought a Balmar pulley kit 48-YSP-3JH-A to my Yanmar with a Hitachi alternator. Now the small pulley on the alternator touch the alternator house and don't move freely. How can I solve this, is the 48-AM-97 the solution? Best regards Johan Carlstedt View answer
Asked 2 ´years ago | Balmar Pulleys > Balmar 48-AM-97 J10 Pulley for Hitachi alternators
