Technical Support Q&A
Activity timeframe
I have a Westerbeke 42B engine with an XT-170 Alternator kit installed. The tach adjustment jumps from very high to very low, with no fine tune adjustment in between. Will this stabilizer work for my application? View answer
Asked 2 ´years ago | Accessories > Balmar 15-TSS Tach Signal Stabilizer
Battleborn lithium battery specs say their ideal charging voltage is 14.6. For your charger, the specs say it will charge Li-ion batteries at 14.2. What difference, if any, does that make? View answer
Asked 2 ´years ago | Victron Blue Smart Chargers > Victron Energy BPC121531104 Blue Smart IP 65 Waterproof Battery Charger 12/15 (1) with Bluetooth
I have a 95 Prevost marathon motorhome I'm upgrading. The Quattro 24/8000 would be perfect specs for my application however I'm wondering if I can use the euro 230 model and an auto transformer to get the 3 wire 240 I need for cooktop? View answer
Asked 2 ´years ago | 24 Volt Quattro 230 VAC > Victron Quattro 24/8000/200-100/100 230V VE.Bus
Will this shunt work with my paneltronic DC analog meter? View answer
Asked 2 ´years ago | Shunts > Victron Energy SHU500050100 Shunt 500A/50mV
Does the Victron Energy ORI241225020 Orion 24/12-25A DC-DC Converter have staged charge levels for maintaining a lead acid battery? I'd like to run it off my LiFePO4 bank to keep my starter battery topped off. View answer
Asked 2 ´years ago | Step-Down DC-DC Converters > Victron Energy ORI241225020 Orion 24/12-25A DC-DC Converter
Is the Temp Sensor for the BMV-702 compatible with the Phoenix 24/25 as spec sheet does not indicate whether or not compatible with this charger and only mentions other chargers? View answer
Asked 2 ´years ago | Temperature Sensors > Victron Energy ASS000100000 Temperature Sensor for BMV 702/712 and Smart Shunt
I would like to enable the device with ignition switch and remote switch. What gauge wire is needed to run to the starter power supply? Does this also require an inline fuse? View answer
Asked 2 ´years ago | Smart DC Chargers > Victron Energy ORI122436140 Orion-Tr Smart 12/24-15A Non-Isolated DC-DC charger
I have bought a Balmar pulley kit 48-YSP-3JH-A to my Yanmar with a Hitachi alternator. Now the small pulley on the alternator touch the alternator house and don't move freely. How can I solve this, is the 48-AM-97 the solution? Best regards Johan Carlstedt View answer
Asked 2 ´years ago | Balmar Pulleys > Balmar 48-AM-97 J10 Pulley for Hitachi alternators
